PARKING BRAKE RELEASE HANDLE REPLACEMENT KIT (GENERIC)

Description

Generic Brake Release Handle Kit
No more wasted time trying to find or make a part that will fit!
This kit includes most everything you’ll need to fix a broken brake release handle, especially if the broken end leaves a straight metal rod sticking out where the handle came off. Just measure the width of the rod and drill out a hole in the hard plastic handle where the metal rod will fit into it. There is a 3mm pilot hole already in this new handle. It is best to use two or three drill bits, so you don't drill too big of a hole, till you reach the hole size where the new handle slips over the rod. Use the included fast drying epoxy and latex gloves to attach the handle.
No more wasted time searching for a part that will fit or trying to make your own.
This handle only takes a few minutes to install and all you need is a drill and a few bits, which every handyman already has at home
.